HeavyDuty: No Discharge

AUDIO: "Fair enough. Follow the instructions to the right of the screen."

Response Options:

Going OK, same topic

• My topic discharged well, seems flat for now, and we should end off the session soon

• Let's address this same topic now from a different angle

Going OK, new topic

• Let's try a new topic with HeavyDuty • Will open in a new window. When you have the new topic in mind you will close that new window •

• I've got a new topic now – let's go to the options

Not going OK

• It hasn't been going so well - let's try some troubleshooting

Write on Report:

__:__ (The time)

Nfjr qalkow mnjhh hyt. . . (Comments as appropriate)

Notes:

Discharge is important

It is assumed that you have rubbing vigorously for at least a minute and have been trying to get a discharge. It would not be accurate to say it didn't discharge without a thorough attempt to get a discharge going.

Session end point reached?

If the session went well, your topic was discharging well and it seems like you have reached the proper end point for the session, then we'll end the session very soon. Click the top link.

Let's try a different angle, same topic

If the session has been going OK, whether or not your topic was discharging well on the just-done group of commands and you want to try a different set of commands, click the "different angle" link.

Light session so far, try new topic

If the topic you've been addressing seems flat, and not much has happened in the session so far and you want to try a new topic, select the "new topic" link. If the session has been meaty so far, it's usually better to end the session and take a break before starting in on a new topic.

Not going well

If the session went badly and/or your topic has not been discharging at all with any group of commands, then click the bottom link, the troubleshooting one.