BasicR3X: SAP — Shock Viewpoint Move Through

AUDIO: "Good. From the viewpoint or viewpoints you have chosen, move through the shock moment or moments from beginning to end."

Response Options:

Not flat

• I have moved through the shock moment(s) from the chosen viewpoint(s) — It's not flat

• Shock moment(s) not flattening quickly: use 6-dir from same viewpoint(s)

Flat

• I have flattened the shock moment(s) from the chosen viewpoint(s)

• Shock moment(s) flat from all viewpoints. • Close this extra window.•

• Shutting down | Don't want to continue | Realization

Write on Report:

List viewpoints, and mark the one you are assuming
VPs: Koeieu <--
Jfhfhrg fgfgr her fgdfy
Kghgg gjgjghgt ij o
Lkkm ryru tiyo lpp iokth

Notes:

Run Shock Moment Viewpoint command

Run through with special attention to the Shock moments from the relevant viewpoints. When you have done so, say aloud Yes or equivalent, and click the appropriate link.

Repeat until flat

If you have already run through it once with this Shock Moment Viewpoint command command and also 6-dir, repeat the run-through and the 6-dir again until it's flat. When it's flat, go on to the next command using the correct link.

Shutting down

If you start shutting down, click on Shutting down at once.

Rub & Yawn when needed as usual